In the New Rough Turn cycle you can now:
Set the new Compensation setting
to None, Controller
Offset or Pathcomp. There
is also a new related CRC Register
setting. The setting is in the General
tab of the cycle dialog. You need to check Canned
Cycle for the compensation setting to be available. Previously
the compensation was effectively fixed at 'Pathcomp'.
Also see the related
Code Wizard changes.
Also note that the 'Feature Name' option has been removed. This is because it is an out of date method off passing information between cycles, that was never fully supported in later cycles. Your existing machining will not be affected.
