Installation
Multiple installations (different versions) of Edgecam Part Modeler (Version 9.0 or later) can be installed on the same PC. However only a single version of Edgecam Part Modeler can be run at a time.
Upgrades
On systems where both Edgecam and Edgecam Part Modeler are installed, they must both have the same version number.
For example if you currently have version 12 of both products, you must upgrade both of them to version 2009 R2, not just one of them.
Note we strongly recommend that:
For Edgecam you upgrade your existing installation.
For Edgecam Part Modeler you uninstall your existing version, then perform a fresh install of the new version.
Install Edgecam before Edgecam Part Modeler (if installing both).
Before installing check the Recommended Hardware and Operating Systems.